Double Cone Bipolar Tesla Coil

My Research

Ideal Tesla Magnifier System
Spiral & Solenoid Combination Coil
Flat Spiral Secondary and Longitudinal Waves
Trifilar Wye Secondary Coil
Tesla Magnifier Experiment
Magnetic Quenching Experiment
Bilfilar Electromagnet Experiment
Bucking Magnet Experiment
Fluorescent Tube Battery
Electrolytic Rectifier
Tesla Propulsion
QADI Lab
Periodic Tables

Tesla Resources

Known Tesla Publications
Articles About Tesla and His Work
Tesla Notes
Tesla Photos

QADI Web Sites

Quantum AetherDynamics Institute
Aether Physics Model
Aether Wizard
Conductance Yoga
Herbal Folklore
Lambdoma Music
Terracycles
Secrets of the Aether
Unified Force Theory
James Clerk Maxwell

Domains For Sale

alni.co
bodhistore.com
delmoni.co
jelly.co
miranet.org
petti.co
sili.co
tiahuana.co
Privacy Policy

Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

Vajra Periodic Table print
Vajra Periodic Table
by Aether Wizard

Formulas

My Inductance Formula
Relationships of Frequency
Experimenter's Handbook
Wheeler - formulas for inductance
Measure Inductance w/o LCR Meter

Of Interest

Tesla Coil Mailing List
High Voltage

Bucking Magnets

This experiment is based on John Bedini's bucking magnets experiment.  

In the original experiment, this device is called a Scalarbeamer.  It is said to generate a scalar beam.  For more information on these experiments visit Bill Beatty's scalar experiment page and this New Millennium page.

Here is what my bucking magnet ended up looking like.  You can click on the image for a closer look.

It is made with two 1.5" × 1.5" × 5/16" neodymium ceramic magnets.  The magnets are so strong I had to make a mold to hold the two magnets into place before I could get them close enough to glue them with super glue.  After gluing the north poles together, I wrapped about four layers of wide electrical tape.  The coil is wound from #24 magnet wire wound in bifilar form with a total of 66 turns.  The two center wires are twisted together and covered with electrical tape as seen in the photo.  

The measured capacitance between the leads is 8 pF and there is no reading for inductance.  I cannot get a resistance reading between the leads.

Below is the general setup I used.  The large cylinder in the background is an aluminum sheet covered with many layers of polyurethane.  This is part of my radiant energy experiments using Nikola Tesla's Radiant Energy patent.  The copper pipe poking through the well cover is my ground.  It is 17 feet deep inside of a well and covered with 16 feet of water.  The bucking magnet is resting in an inverted glass insulator on top of four rolls of packing tape.  The instrument is a standard radio shack digital voltmeter.

When I wired the bucking magnet to ground and antenna, I received a .095 Volt potential across the bucking magnet.

When I disconnected the antenna, I got zero volts.

As time went on during the day, the voltage reading dropped.

 

When I connected a 4.5mH bifilar wound coil across the bucking magnet the voltage disappeared.

When I touched the connection with my hand on the antenna side of the bucking magnet it registered .532 Volts.

After removing the coil and touching the antenna side of the bucking magnet the voltage dropped to .062 Volts.

I didn't get a picture of touching the ground side of the bucking magnet, but touching the ground side resulted in zero volts.

After about an hour, the voltage readings dropped considerably for the various configurations.  I will attempt these experiments again on different days at different times to see of there are fluctuations in the voltage.